4110 VIBRATION
ROBOHA
Join Date: Mar 2004 Posts: 38 FOREST HILL MARYLAND Pics |
2004-04-08 82497
well guys the new tractor has a whopping 12 hours on it.I have experienced a vibration at low speeds when the 3 point hitch is raised all the way up. when I lower it a couple of inches and pick up speed it is gone. is the normal? other wise it hhas tackeled with great success every thing i have thrown at her! roboha
Reply to | Quote Reply | Add Photo
4110 VIBRATION
jdgreen
Join Date: Jul 2003 Posts: 232 Maryland |
2004-04-08 82540
If it only does it when three point is all the way up, It sounds like you are putting the system in relief. Have your dealer check the adjustment. ....
Reply to | Quote Reply | Add Photo
4110 VIBRATION
TomG
Join Date: Feb 2002 Posts: 5406 Upper Ottawa Valley |
2004-04-09 82556
As JD said an out-of-adjustment 3ph may not go into neutral when it reaches full height. The engine will go to full throttle and likely would make a bit of gray smoke, and that might be described as vibration. The relief valve should open in that case and you should be able to hear a squeal.
If the pto is in operation at the time, another possibility is that the angle at full-height is too great for the pto shaft. ....
Reply to | Quote Reply | Add Photo
4110 VIBRATION
DRankin
Join Date: Jan 2000 Posts: 5116 Northern Nevada Pics |
2004-04-09 82559
There is a top detent for the lever to fall into when you raise the 3point all the way. If you pull it a fraction of an inch too high it does what these guys are saying..(good work guys!!!)
I never noticed the problem on my 4100 but I have seen it happen on the 4115. If letting it rest in the detent does not cure the problem it should go back to the dealer ASAP. ....
Reply to | Quote Reply | Add Photo
Go Top
Share This